Mountain Buggy Buggy Carrycot Manual de usuario descargar pdf (Pagina 5)

ENGLISH

Safety Harness

To fasten

1. Clip shoulder straps to waist strap buckles.

2. Push both waist buckle ends into crotch strap.

To release the harness

1. Squeeze the tabs on either side of the main

buckle with thumb and fore nger.

To adjust width for a new born

1. Unclip all straps from the main buckle.

2. Thread the main buckle and crotch strap

through the centre fabric slot on the seat.

3 Thread the side straps

through the side fabric

slots.

To adjust

1. Adjust sliding buckles so

harness straps  t  rmly.

Shoulder Strap Height

Shoulder strap height should be located just below or level with a child’s shoulders.

The older the child, the further up the seat the straps need to be.

To adjust:

1. Locate buckle by slipping hand up the inside back of the seat.

2. Push the rectangular shaped buckle through the

insertion slot on an angle, pushing the corner of

the buckle  rst.

3. Re-thread the corner of the buckle through the most

suitable height insertion slot for your child.

4. Once the buckle is through the slot, twist it so it is

 at against the seat back and then check it is secure

by pulling on strap.

NB: a separate safety harness conforming to British Standard BS6684

may be attached to the two ‘D’ rings located at the insertion of

the waist harness.

NB: Make sure baby is

positioned down as

far as possible in seat.

Centre

fabric

slot

Side

fabric

slot

1 2 3 4 5 6 7 8 9 10 ... 107 108

Sin comentarios

Mountain Buggy Buggy Carrycot Manual de usuario Pagina 5